Drywall Contractor Proper Method in Removing Drywalls

You’ll likely appreciate taking down drywall if you enjoy watching the demolition scenes on home improvement programs. It’s a crucial task that every homeowner should be able to complete. Work carefully to avoid generating too much debris and dust because this is a messy job. Cut up the drywall into big pieces. Pry the drywall off of its fasteners as you work your way down the wall, starting at the top. Don’t try to reuse drywall because it is cheap. Construction glue residue on studs can be an issue, but you might be able to install drywall after using a heavy-duty paint scraper and chisel to remove some of it. But there are some crucial steps you need to be aware of before you start hammering away. The drywall contractor discussed below how to remove drywall in your house securely and efficiently.

Step 1: Preparing Wall

Power should be turned off at the service panel before removing cover plates from wall boxes. Cut through the joint compound and tape with a utility knife if you’re finishing up drywall removal at a wall or ceiling corner. An incomplete removal work is defined as a saw cut made along a stud.

Step 2: Make Handholds

To provide handholds during removal, drill a line of high holes with a hammer along the stud bays. Work cautiously to prevent damaging hidden wiring, heat ducts, or plumbing lines.

Step 3: Remove Drywall

Take hold of the drywall and pull it down, tearing it into manageable pieces. To avoid excessive handling, drop the pieces directly into a disposal container instead of onto the floor.

Step 4: Clean Up

Clean up the studs by tugging nails or backing out screws. Slide a putty knife or the edge of your hammerhead along the stud to be sure you’ve located every fastener. Fasteners should be removed to make the studs safer to handle, even if the wall is being entirely removed.

If you need a Summerville, SC based drywall contractor, call Jones Drywall, LLC today at (843) 562-6482 for an appointment.